How to Do Cable Reverse Flyes Correctly

How To Do Cable Reverse Flyes Correctly 1
Hi, I’m George Yang — founder of YR Fitness and a hands-on fitness equipment designer with over 30 years of industry experience.

Not sure how to do cable reverse flyes without swinging or turning them into an arm exercise? A few small setup changes can make the movement much easier to control.

The quick answer is simple: set the cables around shoulder height, keep a slight bend in your elbows, pull your arms out and back, then return slowly. Use a manageable weight so your rear shoulders stay in control.

As an Exercise Physiology & Biomechanics Expert at YR Fitness, I study how resistance, body position, and movement paths affect exercise. I often see reverse fly form improve as soon as people lower the weight and stop pulling too far behind their body.

Below, I’ll walk you through six simple steps for doing cable reverse flyes correctly. Follow them in order, and you can improve your setup, control, and rear-shoulder engagement.

1. Set the Cables at Shoulder Height

Adjust both cable pulleys to about shoulder height.

Stand between the pulleys and grab the opposite handle with each hand. Your right hand holds the left cable, and your left hand holds the right cable, so the cables cross in front of you.

This setup also matches the reverse fly guidance from the American Council on Exercise, which recommends positioning the pulleys around shoulder height or slightly below and crossing the cables in front of your body.

Start with a light to moderate weight. Reverse flyes do not need heavy resistance to work well.

How To Do Cable Reverse Flyes Correctly 2
How to do cable reverse flyes correctly 8

Quick check: Is it already hard to hold the starting position?

If yes, lower the weight. You should feel in control before your first rep even starts.

Setup Check
What to Do
Avoid
Pulley height
Around shoulder height
Setting cables too high or low
Grip
Hold the opposite cable
Twisting your wrists
Weight
Light to moderate
Starting too heavy
Elbows
Keep a slight bend
Locking or deeply bending them
Body
Stand stable and upright
Leaning or rocking

2. Get Into the Starting Position

Stand in the middle of the cable station and step back slightly until you feel tension in both cables.

Keep your:

  • Feet about shoulder-width apart
  • Knees slightly bent
  • Chest upright
  • Core lightly braced
  • Arms extended in front of you
  • Elbows slightly bent

Do not completely lock your elbows.

I recommend keeping that same small elbow bend throughout the rep. If your elbows keep bending and straightening, the movement starts looking more like a row than a reverse fly.

The cables should also move smoothly as you get into position. You should feel tension without fighting the machine before the rep even begins.

At YR Fitness, we design our commercial cable equipment around smooth resistance, stable movement, and practical adjustment positions. If you want to compare different cable setups for movements such as reverse flyes, rows, and other upper-body exercises, explore our strength and cable equipment here.

How To Do Cable Reverse Flyes Correctly 3
How to do cable reverse flyes correctly 9

3. Pull Your Arms Out and Back

Now open your arms out to both sides in a wide arc.

Think about spreading your arms apart, rather than pulling the handles backward like a row. Keep your torso still while your arms move.

Stop when your arms are roughly in line with your body or when you reach a comfortable range of motion. You do not need to force your hands far behind your back.

Here is why this matters: your goal is controlled shoulder movement, not simply moving the handles as far as possible. Mayo Clinic’s weight-training guidance also stresses using proper form and lowering the weight when technique starts to break down.

Should you use momentum?

No.

If your chest rocks forward and backward on every rep, the weight is probably too heavy. Reduce the resistance and keep the movement steady.

How To Do Cable Reverse Flyes Correctly 4
How to do cable reverse flyes correctly 10

4. Squeeze Your Rear Shoulders

Pause briefly at the end of the movement and focus on your rear deltoids and upper back. The reverse fly targets the back and shoulder area.

Your shoulder blades will naturally move toward each other. You do not need to squeeze them as hard as possible.

I often use one simple cue:

Open your arms, not your chest.

It helps keep the exercise focused on the movement of your shoulders instead of turning it into an exaggerated upper-back squeeze.

Also avoid shrugging. Keep your shoulders away from your ears throughout the rep.

What if you mostly feel your traps?

First, check whether you are shrugging as you pull. Then reduce the weight and try again with your shoulders relaxed.

How To Do Cable Reverse Flyes Correctly 5
How to do cable reverse flyes correctly 11

5. Return Slowly

Once you reach the end position, slowly bring your arms back toward the front.

Do not let the weight stack pull you forward. The return is still part of the repetition.

Use this simple rhythm:

Open → pause → return slowly.

The American College of Sports Medicine also recommends lifting and lowering resistance in a controlled manner in its resistance-training guidance. That is a useful rule for cable reverse flyes too.

If the weights slam back into the stack after every rep, slow down or reduce the resistance.

Keep your shoulders controlled from the start of the rep to the finish.

How To Do Cable Reverse Flyes Correctly 6
How to do cable reverse flyes correctly 12

6. How Many Sets and Reps?

For most fitness lovers, keep it simple:

Training Level
Sets
Reps
Main Focus
Beginner
2–3
10–15
Learn the movement and stay controlled
Intermediate
3–4
10–15
Add resistance while keeping clean form

Choose a weight that lets you complete every rep without swinging, shrugging, or changing your elbow position.

I often see people add weight before they fully control the exercise. In most cases, the reverse fly feels better once they back off the resistance and slow down.

Increase the weight only when you can finish your current sets with clean form. Mayo Clinic similarly suggests starting with resistance you can control for roughly 12–15 repetitions and increasing it gradually as you get stronger.

You can include cable reverse flyes in an upper-body, shoulder, or back workout. They often fit well after your main pressing and pulling exercises.

How To Do Cable Reverse Flyes Correctly 7
How to do cable reverse flyes correctly 13

Final Thoughts

Cable reverse flyes work best when you keep them simple. Set the cables around shoulder height, maintain a small elbow bend, open your arms out to the sides, squeeze your rear shoulders, and return slowly.

Good movement matters more than chasing heavier weight. If your body starts swinging or your shoulders start shrugging, reduce the resistance and clean up the rep first.

If you want to see cable and strength machines built for smooth, controlled training, browse the YR Fitness commercial gym equipment range and compare the available training setups.

Related articles: